Firstfives.org

Metal assembly is out, rubber cover pulled back. There is a black plastic cap with the wire connectors fitting (too) tight in/around the metal access port to the light bulb.

Do we unplug the assembly further inside the car (harness) or do we use a pliers to (gently) twist, pull the black plastic cap out of the metal piece ?

If you look past the assembly into the inner fender, the rubber covered wires go through a small hole to a white cylindrical plug. ( Not shown or described clearly in any manual or parts drawing.)

The whole metal turn signal assembly, with the wiring tail on it, will come out.

Thank you for your help, other me. No problem.

And I thought I was the one that had such conversions. Thank you guys for responding to each other.