Giubo

Post your E12 technical questions and comments here. Please, no off-topic posts.

Moderators: Mike W., Pierre

User avatar
528i-1981
Posts: 557
Joined: Wed Feb 07, 2018 5:50 am
Location: Franklin, TN

Re: Giubo

Post by 528i-1981 »

I was thinking about ways to move the knob backwards. Other than shortening the linkage, bending is really the only option (there is a bend in the shifter). What might make bending slightly laborious is that the outer aluminum trim turning is potted into place with silicone, but there are clearly set screws holding it to the inner main shifter rod. Using heat would require disassembly I think, but doable.

Here's the photo Ron at Auto Solutions sent showing the assembly out of the car.
Image
(oo=00=oo) Eric
1981 528i Manual
User avatar
528i-1981
Posts: 557
Joined: Wed Feb 07, 2018 5:50 am
Location: Franklin, TN

Re: Giubo

Post by 528i-1981 »

528i-1981 wrote: Fri Jan 27, 2023 9:47 am The only downside is that the shifter geometry is now a bit farther forward, so that your knuckles hit the cigarette lighter going into 3rd.
Mea culpa, mea culpa, mea maxima culpa. I had the shift lever rotated 180 degrees. I read on the Auto Solutions site somewhere they it's easy to get it wrong, and if you do the shift pattern will be forward and toward the right. Luckily, you can fix this without dropping the exhaust or the drive shaft with a little patience. It's nice being able to drive without the bottom of the steering wheel in my gut.
(oo=00=oo) Eric
1981 528i Manual
Post Reply