Crank /Pulley nut size ?

alotawatts · Post by **alotawatts** » Sun May 31, 2009 12:31 am

Need to know the socket or wrench size for the main front crank/pulley nut .... 36mm ?
thx

Bert-Ola · Post by **Bert-Ola** » Sun May 31, 2009 3:57 am

Yes, 36 mm are the right size.

Big Dog · Post by **Big Dog** » Sun May 31, 2009 8:16 am

36mm is the correct socket size but the torque on this sucker is huge, something around 300 lb ft. If you are building a really hi-po motor you should consider the Frank Fahey crank hub, expensive but worth it. I have seen front hubs crack and break on track/race cars that are driven at high rpm consistently. That being said, I have also seen stock motors go on track and run for thousands of laps without a problem. It probably has something to do with driver smoothness and just dumb luck.

Firstfives.org

Crank /Pulley nut size ?

Crank /Pulley nut size ?

But you better have a really long wrench