Looking for suggestions for installing this PITA gasket I just took off from the rear of the engine.
There are 6 screws holding this little plate and gasket to the engine, does anyone have any do's and don'ts for preparing what I think is a paper gasket for proper install?
Attachments
PXL_20241025_191644829.MP.jpg (40.68 KiB) Viewed 28469 times
Yes, one of the bolts uses a special washer/seal. I can't insert the image, but open the link and it will show. (it's a no hotlinking thing by the owner of the server)
I also like to use Permatex #3 as an additional sealant on both sides of the gasket.
02 525ita. Wife's, aka grocery getter
02 530i. New to the fleet, 3 pedals.
08 Toyota 4Runner. 4WD vacationmobile. No enthusiasm, but it didn't leave me stranded or use any oil. Reserving judgement for now.
